13. RS 232 PARAMETERS
External devices connected to RS 232C have to be supplied from the same
mains and common electric shock protection. It prevents from appearing a
potential difference between zero leads of the two devices. This notice
does not apply to the devices that do not use zero leads.
Transmission parameters:
x Baud rate - 2400 – 38400 bit / s
x Data bits - 7,8
x Stop bits - 1,2
x Parity control - no, even, odd.
There are four ways of sending data via RS232 interface:
x Manually – after pressing
,
x Automatically – after stabilizing the indication over LO threshold
x Continuously – after it is activated in parameter or by a command
sent via RS232
x On external request - see - „List of scale - computer commands”.
The indication can be sent as:
x stable – the indication is sent after the scale stabilizes.
x any – the indication is sent immediately after pressing the
key,
this state is assign with <?> in the printout.
13.1. Printout type
This parameter is to select the type of printout.
Procedure:
x Enter the submenu <P2.Prnt> and then:
- 30 -
Comments to this Manuals